Quote:
Originally Posted by 351mustanger
Just clamp a small vice grip onto the screw and break it loose. Then replace the screw. Check the pilot jet. It probably has a small piece of trash clogging it.
|
dremel charged and I FINALLY got that screw off (and already scavenged a replacement from a free carb that came with the kart!)
Jet's are perfectly clean, but can I run anything through them to be completely 100% sure? I could see through them, ran a strand of copper from an electrical wire through to be sure no particles were in there and I got nothing, the rest of the inside of the carb is squeaky clean. Also, how do I measure my float height?
Thanks guys!