Ok, I hooked a volt meter to the CDI, the volts coming to the CDI Power is 12.56v,,,the power going to the ignition coil and the trigger feed from the CDI is right around 6.5v, should this be about right? unhooking the coil and hooking a volt meter to the coil wires shows 0.3 volts Volts to the starter is right around 12.5v, once the front kill switch is engaged the starter drops to 0.00, so the starter is getting power and is cranking and working correctly. Does the CDI send power to the coil wires that connect to the coil, if so then from 6.5 volts down to 0.3, something is wrong,,, What next guys?
|