ok, reverse cable is in, fenders are on, 2nd seat is under construction and the shifter is installed. eric and i discussed the pleats in the head rest because they bothered me. he didnt heat the 1st set because he prefers a blowdryer over a heat gun because he had had experience where heat guns were a lil too hot. i asked him to give it a try on the second set. turned out much better. well last night i must've made the head rest rails on the 2nd seat a lil taller so the headrests that i pre cut are not big enough. tomorrow i'm going to use the new headrests to replace the seat for talon # 1, because i just think they look better. then i'm going to cut new taller head rests for talon # 2. this will work out better i think because # 1 is for miami eddie's son's girlfriend and #2 is for his son who is taller any way. we ended up doubling up on the foam on # 1 to push her forward and up because she is a bit shorter. at this point i'm just waiting on the seat belts and to replace the master and bleed the brakes and hopefully friday afternoon.............TEST DRIVE.
ready for pickup on saturday!
__________________
"LUCIFER" JOYNER JD400,
CROSSHAMMER 250R,
YERF GX150,
CROSSFIRE MBX150,
BMS 800V-TWIN
'16 RZR 900s ,
'17 ACE 900XC,
'99KX250,
'94 KDX200,
'18 SSR SR170TX
|