Moment of truth
Alright. I ordered the motorio pulley from Ebay along with a lightweight drive face and the posted variator 115mm. It does in fact allow the belt to travel quite a bit further into the rear pulley and up the variator face. Just placing the belt in the opened pulley and grabbing it like a cup, the diameter went from around 4' to about 2 1/2. That's quite a difference. I only got in a short test run (no GPS) and it had better bottom end and I never got it wound all the way out and it was already faster than before. Granted I went from stock variator to 115mm and added this pulley also, but even if you already have a 115mm variator I do believe that as advertised you could easily claim an extra 4-7mph from the pulley alone. Maybe even a tad more. I am VERY impressed with this setup and will post more when I get the GPS on it. I also put a ported and polished and milled performance head from SYC and did some other things so I have to tune it all in before I know final results. MORE TO FOLLOW. If you were on the fence about that pulley.........It's worth every bit of $84. 
http://www.ebay.com/itm/170980209035...84.m1497.l2649
http://www.ebay.com/itm/170966203892...84.m1497.l2649
__________________
MXR TrailBender 160R
SYC Perf head P&P,Matched intake and exhaust, A12 cam, Orange CDI & coil, Motorio pulley, 115mm Variator and lightweight drive face,11gm Sliders, UNI, modded muffler + 200 horsepower 
http://www.youtube.com/watch?v=3hx-hEWl10c
I'll take your insults as compliments and blame it on your lack of intelligence.
|