[rocko]

today I was able to order 3) 1" heavy duty pillar bearings , 1) 36" shaft that is keywayed 1/4 x 1/8 ( only need 24" 's but 36 is the only way they sell it ) and a 20 toothed sprocket ( 3.93 ratio) for $80 with the freight and dropped off the OEM Crossfire 150R output double chain sprocket at the machine shop , they are going to bore the spline out and make it 1 1/2 i.d. then fab a hub 1 1/2 o.d. and 1 " id and keywayed , press in the hub then weld it with TIG , the hub will stick out both sides the sprocket 1/2 " with a set screw over the key , I found a double chain sprocket in 1" key bore but they wanted $106 and a month delivery ------------yesterday I cut, trimmed and grinded the frame into a craddle to mount the engine to and it doesn't look 1/2 bad , still not sure if this is the way I will go