200sx
Hope to get the sprockets and shaft by Wenesday or Thursday , really don't want to go any farther trimming the frames till after the jack shaft is built , think of welding the frame to a 1/4 plate of steel , weld two runners across the swing arm and bolt the plate to the swing arm with slots for chain adjustment , two nuts welded to the plate on top a shim and a couple of bolts thru a hole in a piece of angle iron welded to the swing arm will adjust the chain , on the jack shaft I am thinking of using the two stock Crossfire chain adjusters and a double holed link attached to one of the two pillar block mounting bolt ------------------- hers's another view without engine
|