I moved mine when I first got it and it ran fine.
I also looked into dropping the rear axle mounts on the swingarm. Mine is built out of rectangle tube 1 inch by 2 inch if I recall. I was gonna get 2 pieces of that about 1 foot long and stack it on the bottom of the swingarm where the factory bearing supports was attached. Then weld the supports to those 2 inches lower. Need a longer chain but the factory engine angle would remain the same.
Two maybe 3 inches would be all I would try using that method. Anything more than that I think you would have to add too much weight bracing it all up to keep it from folding over from the lateral force of turning.
Last edited by neo71665; 10-06-2017 at 02:36 PM.
|