kiora = maori greeting
- Gl 500 no starter reverse
- suspension double wishbone front and rear with inboard coil overs on the front and regular on the rear
- Drive line ,GL 500 -> "short" chain drive to fixed drive shaft between two identicle LSD 500cc ATV diff's -> half shafts with C.V's to the hubs that im fabbing up to get correct geometry. Drive shaft will have two carrier bearings to support the length and any drive deflection,Two uni joints also for alignment (design engineer bother in law is doing calcs for span speed and strength), Also on the drive shaft i hope to have a ring gear to drive in reverse with 12v starter motor out of a small car{Select N then hit button to engage rev}.
{all this is still in the design stage at the moment}
- 12v winch for those sticky spots
- the brakes I'm hoping to have a simalar setup th jaguar rear diffs with inboard disc's on the front and rear.
Phew
i tink thats it i hope it all works out as planned im sure there will be plenty of hitch's on the way , But i wanted a good challange that's why the 4wd.
