ok now i got the harness and ground figured out everything seems to start. I was running the buggy and notice that there was some grinding noise and took off the cv cover and it had come loose and was grinding on the cover. i'm not sure what the PO did to this buggy but now when i try to tighten the nut on the variant it keep's coming loose maybe the PO put the variant i assume that is want it called coming out of the engine with the roller's etc in it. there is a big washer with groves and edges on the one side does the side with the edges go in towards the variant or the nut or maybe that is the wrong place it goes i'll post some pics tomorrow to show what i'm talking about
|