Ok guys,
I tested the enricher/auto choke and this is what I found.
After 5 minutes of heat (current on) it expanded (best measure with ruler) 5/16 inch or about 7.94mm. Which from what I read I think is in the O.K. zone?
After 5 minutes of no heat (current off) it did not move at all (if it did it was extremely small amount). and still held at an expanded length of 5/16 in.
I took another autochoke off the carb I replaced and started it up and reved her a few times in the garage. She sounds good, but to know for sure if my problem is fixed I need to give her a test drive and get it up to operating temp and see if my problem still occurs. Right now its pooring rain and has been for 2 days. I dont want to drive it down the road and then something happen..... I may have to wait. Maybe in an hour or two the rain will have stopped and I can drive it down the street.
I thought the point should detract and go back into the module after the heat had been off for 5 minutes (at least some noticeable amount). Does this sound like my problem guys?