05-14-2012, 09:44 PM
|
|
Super Moderator
|
|
Join Date: Aug 2009
Location: Belmont,NC (elevation 534')
Posts: 2,668
|
|
These show the change from the stock ball joint type steering arm end of the rack to Heims with a clevis. If the rack has been grooved for more travel- Regardless where the rack is mounted you'll need to have the pivot point on the clevis at the end of the rack just to the outside of the A-arm pivot points (ckau's cad calculations suggests 5/8"). These steering arms allow for LOT'S of travel. The ones pictured travel more than 11".
|