View Single Post
  #137  
Old 09-07-2013, 09:31 PM
Masteryota's Avatar
Masteryota Masteryota is offline
Senior Member
 

Join Date: Dec 2012
Location: North Florida
Posts: 1,155
Default

I need some input, I know we touched on it before, but I want to makes sure I am not setting myself up for issues later. I am finalizing the mounts on the engine, and can not seem to find a decent way to grab the head stay or upper rear mount without getting in the way of the exhaust or carb and intake boot. I made a new lower mount and added some angle to grab some threaded holes in the case near the same mount, and I am planning on boxing the mount to also grab the other end of the bolt. The mount is still removable to assist in engine removal without cutting.
Attached Images
File Type: jpg 2013-09-07 19.30.07.jpg (91.8 KB, 28 views)
File Type: jpg 2013-09-07 19.29.44.jpg (95.1 KB, 23 views)
__________________
ASE Master and Toyota Master Diagnostic Certified
Buggy Building Trainee

'04 Dazon Raider 150 'modded'
Reply With Quote