Make sure all of the passages are clean, and remove the jets and make sure they are not clogged. I had issues with mine moving junk around and clogged the pilot again after I cleaned it thoroughly. Finally got it to idle the 3rd time I cleaned it....
Some swear by the torch tip cleaners to clean out jets, but be careful as they can actually open up the jet slightly, I use some 18ga electrical wire and strip it back about an inch and use individual strand of wire to clean the jet holes and pilot/emulsion tube.
__________________
ASE Master and Toyota Master Diagnostic Certified
Buggy Building Trainee
'04 Dazon Raider 150 'modded'
Last edited by Masteryota; 05-21-2013 at 05:55 PM.
|