Pulled the carb apart today, was stupid clean. Cleaned out everything anyway. Kart starts but I don't know how it will run. Took a guess as to where the mixture screw should be. Says to lightly seat and then back out 1.5 turns, don't know how you tell if it's seated or not? Also figured out the ground has to be on the middle terminal of the on/ off switch or the kart won't shut down.
Not electrical but anyone have any advice on getting a stock carb to clear stuff when it's on a 30mm intake? According to b.d. it's a guaranteed fit that may or may not work... the fuel bowl and drain line hit the bolt that holds the engine in the cradle, if I raise the carb up it wants to flood out. Have a uni filter I want to put on so I don't suck junk into the carb...
Happy new year and thanks for the help.
|