Yeah it's frustrating. Of all the manufacturers of these cams I'm yet to find an actual spec for one. Surely there is a manufacturer out there that makes repeatable cams. Even the descriptions for the taida cams vary between vendors. Once I prove out the cam profiler I've got to determine which of the three Taida cams would make sense for my engine/needs with very little to go off of.
I'm planning to profile both intake and exhaust simultaneously. It will be easier to set up if I measure at a 90 degree angle from the head surface. Later when I've got the lift/rotation data in excel i would then have to adjust for the angle offset of the lifters. Anyone know the angle the lifters contact the cam? Or how many degrees they are offset?
|