Update-and a new problem.
Ok, dump simple error. I took the spring loaded top off the carb and the needle insert was not fully engaged downward where the needle seats into the main jet...duh. Must have happened when I cleaned the carb and put it back together. Now it runs as before.
But now that I've read all these posts..it's not running right yet. Does not go completely to WOT top speed. It sputters and backfires a bit at full throttle.
Also, when running especially under heavy load, it feels like the chain "skips" every 5-10 seconds. Almost like you had just run over something. Is that the CVT having an issue?
I'm completely new to the CVT concept.
|