x-bird- thanx for the link. The only time I have an issue with hole saws is when the inner cut piece tries to get out the slot of the saw. I did good!! didn't even loose a tooth in about 30 cuts.
Figured I share some pic's of the balance of the front end re-fab.
Pic's show the A-arm tabs and installation of them. To make sure they all ended up being spaced properly I just cut a tube for the center and bolted the whole thing together. I knotched the already beefed up bulkhead and welded in the whole A-arm set-up- worked well and fast!!! made it easy to line the A-arms up. Then I made some shock brackets & done!!!!
|