BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

Go Back   BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum > Technical Discussions > 150cc GY6 and Under Engine Tech

150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum

 
 
Thread Tools
  #1  
Old 08-18-2009, 11:38 PM
BuggyMaster's Avatar
BuggyMaster BuggyMaster is offline
Administrator
 

Join Date: Jul 2009
Posts: 2,312
Default American Sportworks Helix Service Manuals

Attached below are the service manuals for the American Sportworks Helix (Model 6150).
  #2  
Old 08-19-2009, 02:54 PM
24evanwilson's Avatar
24evanwilson 24evanwilson is offline
Senior Member
 

Join Date: Jul 2009
Location: Indiana Mostimes, NC sometimes
Posts: 1,253
Default

a,ready seen em lool
__________________
MY HELIX
-20' maxxis tires
-1 1/2in.UNI air filter
-gutted exaust
-extended lugs
-headlights
-reflectors
-my stickers
-adjusted suspension
-ground out hubs
(to fit on the tires)



helix 150
  #3  
Old 04-04-2010, 12:43 PM
ND2BFSTR ND2BFSTR is offline
Lurker
 

Join Date: Apr 2010
Location: North Carolina
Posts: 9
Default

Thanks, these will really help me out.
  #4  
Old 05-23-2010, 09:09 AM
ND2BFSTR ND2BFSTR is offline
Lurker
 

Join Date: Apr 2010
Location: North Carolina
Posts: 9
Default

Is the GY6 150cc the long case or short case? Specifically the one in the Fox Helix.

Did they use both types? How do you know which one you have?
  #5  
Old 07-07-2010, 09:13 AM
taitethomas taitethomas is offline
Lurker
 

Join Date: Jul 2010
Location: Williamsport, PA
Posts: 7
Default

anyone have any suggestions for performance parts to put on my stock helix 150
  #6  
Old 07-07-2010, 10:09 AM
BuggyMaster's Avatar
BuggyMaster BuggyMaster is offline
Administrator
 

Join Date: Jul 2009
Posts: 2,312
Default

taitethomas, what kind of riding do you mostly do? Generally slow with a lot of hills or more wide open throttle in wide open fields or something?
  #7  
Old 07-07-2010, 10:28 AM
taitethomas taitethomas is offline
Lurker
 

Join Date: Jul 2010
Location: Williamsport, PA
Posts: 7
Default

little bit of everything. i run it on the road quite a bit so i like the speed. having the acceleration wouldnt be bad. i do go on some trails..haha not very specific am i?
  #8  
Old 11-10-2010, 11:56 AM
turnouts turnouts is offline
Lurker
 

Join Date: Nov 2010
Posts: 4
Default Help!

I purchased an after market GY6 engine to replace the engine on a chinese scooter, but the wire colors and connectors do not match those on my scooter. What can I do?
  #9  
Old 01-03-2011, 06:52 PM
MudRunner03 MudRunner03 is offline
Lurker
 

Join Date: Jan 2011
Posts: 16
Default helix

Quote:
Originally Posted by BuggyMaster View Post
taitethomas, what kind of riding do you mostly do? Generally slow with a lot of hills or more wide open throttle in wide open fields or something?
I have the helix 150cc i usually mud bog.. trail ride that sort of thing.. what do you think would be good upgrades for thatt?? also do you think an upgraded filter would help on a gocart?
  #10  
Old 05-31-2011, 07:36 PM
jayafeely jayafeely is offline
Lurker
 

Join Date: May 2011
Posts: 11
Smile You Are A GOD

Quote:
Originally Posted by BuggyMaster View Post
Attached below are the service manuals for the American Sportworks Helix (Model 6150).
thank you so much for posting these,.i purchased 2 helix 150, an they want to sell me a manual,get real thank you Jay Feely, sami29@comcast.net
  #11  
Old 06-18-2011, 02:40 PM
esnewt esnewt is offline
Lurker
 

Join Date: Jun 2011
Posts: 3
Default spark plug

am i crazy or blind, I cannot find the spark plug on the Helix 150. Help!
  #12  
Old 06-18-2011, 05:05 PM
jayafeely jayafeely is offline
Lurker
 

Join Date: May 2011
Posts: 11
Talking lost sp plug ,,hahahhaha

kneel down on right hand side .lean over right rear wheel,directley undre gas tank,locate cylinder head,the plug is on the right side of the cylinder head,aboult 4 inches back at a 50 dgree angle,,never heard of not being able to find the plug OMG,i find it funny sorry,
  #13  
Old 06-18-2011, 05:08 PM
jayafeely jayafeely is offline
Lurker
 

Join Date: May 2011
Posts: 11
Talking do it

Quote:
Originally Posted by MudRunner03 View Post
I have the helix 150cc i usually mud bog.. trail ride that sort of thing.. what do you think would be good upgrades for thatt?? also do you think an upgraded filter would help on a gocart?
1st thing i did was take the muffler out an cut the welded end an remove bafffles then weld end cap back on gained more spped an top end, an sounds cool, then i richened the carb by backing out th brass screw on the left side of the carb,
  #14  
Old 07-11-2018, 10:08 PM
COLDSTEEL's Avatar
COLDSTEEL COLDSTEEL is offline
Lite Contributor
 

Join Date: Jun 2018
Posts: 43
Default

So, I have the same scenario. No spark. It never ran. I just got it. I have been doing a 3 day long trying to figure out where the black/red and Blue/yellow (from strator) go. It cranks and only a few times it started but doesn't keep running. I have a DC CDI. The blue/white is connected via bullet connector to the blue/yellow. Does the black/red go to CDI? I clipped all the "kill switches". I have checked all voltages. Can the cdi intermittently work? I also cleaned and sandpaper the contact on strator. I hope I don't look like trolling. The OP is closest I found to same. I was told it runs I haven't been with any luck. I just purchased a new cdi/spark plug wire but the cdi was AC not DC. So I still kept the spark plug wire.
__________________
HELIX 150cc
  #15  
Old 07-12-2018, 11:09 AM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

Blk./red wire is not connected. Are you sure it is a spark problem and not a fuel problem?
  #16  
Old 07-12-2018, 11:28 PM
COLDSTEEL's Avatar
COLDSTEEL COLDSTEEL is offline
Lite Contributor
 

Join Date: Jun 2018
Posts: 43
Default

No fuel problems. Getting fuel. Confirmed it via spark plug hole. So, I do not need the black/red wire hooked to anything? Only the blue/yellow that connects to blue/white coming from CDI? I am just ruling out electrical.
__________________
HELIX 150cc
  #17  
Old 07-13-2018, 08:33 AM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

The blk./red wire was used on the old ac system. Scroll to top of page and download the electrical manual and it will give you steps to trouble shoot.
  #18  
Old 07-15-2018, 11:09 PM
COLDSTEEL's Avatar
COLDSTEEL COLDSTEEL is offline
Lite Contributor
 

Join Date: Jun 2018
Posts: 43
Default

Quote:
Originally Posted by SYCARMS View Post
The blk./red wire was used on the old ac system. Scroll to top of page and download the electrical manual and it will give you steps to trouble shoot.
OK, so being the Helix 150cc uses DC, I am assuming I don't need Black/Red hooked up to anything. I am confirming this became both the electrical schematics (above) and other pages I did my due dilligants all say it goes "Power to CDI". There is a mate to Blue/White that I have hooked up to Blue/Yellow (coming from stator). Just making sure I am not missing any wires. I am still having starting problems and I am troubleshooting each components.
__________________
HELIX 150cc
  #19  
Old 07-16-2018, 09:40 AM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

You have to read the t/s section for ignition. It says the b/r wire is not used for the cdi, it is used for testing purposes only. Read the instructions carefully for it tells you hoe to check with a volt ohm meter.
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:28 PM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.