|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
 |
|
|
Thread Tools |
|
#1
09-01-2011, 04:14 PM
|
||||
|
||||
Quick question
How much oil do you use in the Carbide's transmission? Also, what is the weight of the oil? I guess that was two questions...
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! 
|
|
#2
09-01-2011, 07:26 PM
|
||||
|
||||
|
Most of them call for 10w-40w as mine does, I use 95w gear oil. Went back and looked at your pic's for the fill & drain bolts/locations. It appears your fill tube is the vent (rubber hose), the drain looks like a bolt in the very bottom of the case (still installed in your pic's). You'll need to check the manual for the amount and exact weight oil. My info is a label on the gearcase. I know it doesn't take very much oil, only covers about half the bottom gears.I use heavier oil to make sure that the gearbox doesn't get over heated and 95+ oil doesn't foam up as much when abused.
Last edited by metalstudman1; 09-01-2011 at 07:36 PM.
|
|
#3
09-01-2011, 10:02 PM
|
||||
|
||||
|
Thank you.
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE!
|
|
|
|
