|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
 |
|
|
Thread Tools |
|
#1
10-10-2011, 05:15 PM
|
|||
|
|||
what clutch to get carbide 7150. Upgrade or stock?
I have two carbide 7150 that both need new clutches.
We mainly run on flat ground but are going to start going on some trails with hills. Also I have heard discussions on changeing the variator roller (What weight), different clutch springs (What size). I guess what I am asking for is what is the best setup since I already need to replace the clutches. Also any suggestions on place/brand to purchase. 
|
|
#2
10-11-2011, 08:26 PM
|
|||
|
|||
|
decision
OK I looked over the site for several hours last night and here is what I think I will do.
Prodogy clutch (would love the dr pulley cluth but too much $$ for now)  1500 yellow clutch spring 12 g rollers Is ths a good setup for my application? Last edited by tybic; 10-11-2011 at 11:10 PM.
|
|
#4
10-13-2011, 03:08 PM
|
|||
|
|||
|
Parts are ordered!!!
Ordered parts from Tom @SYC Powersports:.
 Prodogy clutch 1500 spring set of 10 and 12 gram to see which ones i like with the set up. I will let you know how it runs after they are going. Last edited by tybic; 10-29-2011 at 07:44 PM.
|
|
|
|
