|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
|||
|
|||
Spiderbox motor
|
#2
|
|||
|
|||
It looks a lot more ruff in person.
|
#3
|
||||
|
||||
You would be surprised how rough they look, but still run like champs. Pull the carb and clean it really well and flush the tank really well and see if it runs. Also, if you have a compression tester, that will tell you if the internals are ok. An oil change and new plug and it might surprise you. My Howitt looked the same, and it ran pretty good and is now on a BN members' cart with no issues.
__________________
ASE Master and Toyota Master Diagnostic Certified Buggy Building Trainee '04 Dazon Raider 150 'modded' |
#4
|
|||
|
|||
I know I can get it to run. I need another swing arm though and I was thinking that to get one from BMI it is going to cost me $105 shipped. A complete engine cradle is only $250. I have a buddy that is going to pick it up for me. So for $150 more I can have another complete engine. I'm just not sure how good the used old stock engines are from BMI.
|
Thread Tools | |
|
|