Need help with Howitt gy6 cart

[Larry33]

Bought a used gy6 cart that was well taken care of buy older user. I noticed it seem like the clutch would slip going up hills. I replaced the clutch and it was better but still had this lurch at time going up hill.

I decided to change the belt and bell cover. Same size as the original. Now it moves in reverse as soon as you touch the peddle which it did not before until you gave it gas,
but now looses power going up hill to were you have to back down and get a good run on before you start going up. Could the belt be too tight?

Any suggestions?

[Miamieddie]

Check ur variator weights. It might of shifted. Make sure they're in correctly. They might of moved when you replaced ure belt. Clean them while your at it.

[Larry33]

I had replaced them before and did not have a problem. I was able to replace the belt without removing the front pulley.

[Miamieddie]

Jack the rear up take off cvt cover and run it. See what's going on in there with the belt.