![]() |
![]() |
|
New Member Introduction New to the forum? Say hello here! |
View Poll Results: carbide150 set it up for speed or torque | |||
speed |
![]() ![]() ![]() ![]() |
0 | 0% |
torque |
![]() ![]() ![]() ![]() |
3 | 100.00% |
leave it alone |
![]() ![]() ![]() ![]() |
0 | 0% |
Multiple Choice Poll. Voters: 3. You may not vote on this poll |
|
Thread Tools |
#1
|
|||
|
|||
![]()
hey guys,
new to the site and buggy world.found so much info here on diffrent subjects i googled i had to join!!!!! i just bought a 08' carbide 7150 for $400 ![]() ![]() ![]() only problem is...as of now i cant even bring them home from my younger brothers house, im not verry talented in the small engin dept ![]() ![]() Im smart enough that with a little guideance i can probably get all of these mods done without harassing him to the point where he dosent want to help me ne more at all ![]() This is where u guys come in hopefuly,what i am looking for exactly is reccomendations on witch torque&clutch springsto use and when changing them do u need to do them both equally? what results should i expect to see when doing so???? also after i switch the stator ect. will i need an up graded modifyer/regulator? thanks for being sooooo helpful to nubies like me with ur guys help i might even teach him something(someday)!!!!! ![]() please respond im looking for any input!!!!!!!! |
#2
|
||||
|
||||
![]()
1. If the stock clutch is fine, don't replace it until it wears out
2. Get 12g slider weights and a 2000 RPM torques spring 3. Your GY6 is a short case version. You need a 743-20-30 belt 4. An 11-pole stator requires an 11-pole flywheel and a 3-phase rectifier/regulator to work properly |
#3
|
|||
|
|||
![]()
r u sure the 842 belt wont fit? even with a new race variator?
|
#4
|
||||
|
||||
![]()
That belt is for a long case GY6 engine used on big wheeled scooters.
|
#5
|
|||
|
|||
![]()
so what would be the best upgraded size for this short case gy6?
|
#6
|
||||
|
||||
![]()
You have to stay with the correct belt size for your size case. You need a 743-20-30 belt.
|
#7
|
|||
|
|||
![]()
i had heard a rumor on this site about using a slightly longer belt to give u a few extra mphs. 8 series belt is deff wrong so thanks 4 the info man
|
#8
|
|||
|
|||
![]()
There is a chance you can go with a longshaft pully. Although I can't say for sure how it will work on that type of engine.
__________________
Vincent Kruse - MBRA Vice President National League Director 607-768-6831 570-267-0711 If it ain't broke. DRIVE IT HARDER! |
|
|