Ideas on how to make this part?

[tybic]

The attached picture is the part I need to make. It's the hose that goes from the air cleaner to the carb on a carbide 7150 GY6. Can't find it for sale. Anybody made one in the past? Ours has ripped. Thanks

[xlint89]

Have you thought about using the UNI filter and losing the stocker?

[tybic]

No what would the cost be on that?

[rebellinredneck]

Not too much. I bought a spectre reusable filter with adjustable outlet from advance auto for $20. Use the 4 inch size of it. Go to a plumbing supply store and get a 3 inch to 2 inch reduced which is around $8 and a 1.5 inch to 1.5 inch rubber coupling about $5.

[xlint89]

I don't know specifically on your model, but most of them just consist of a rubber coupling, a small piece of pipe (usually from the plumbing dept at Home Depot) and the UNI filter. Also known as the "redneck intake".

Pipe cost is around $5 and the UNI filter is around $20ish. Many guys like Rebel have done similar stuff like this.

Do a search for "redneck instake" and see what you can find.

[tybic]

Thanks I'll check it out.

[BuggyMaster]

Ya other than the filter itself you can get the parts at Home Depot. I thought there was a thread on this from a long time ago in the tech section.