Need Help - Carter Talon FX150IIR

[Gawald]

Can someone make pictures of the 5 wire ignition switch, engine kill switch, and headlight switch wiring hook up? A dog chewed up my wiring harness and the connectors are missing and I am left with bare wires. I have downloaded the wiring diagram from the Talon GX/FX/DLX 150 manual but my wiring harness does not match the wiring diagram in the manual. Wiring color and the switches are different.

My switches are as follows:

ignition switch - 5 wires coming out of back of switch with no connectors on wires. Colors of wires: Red, Brown, Black, Green, Green with white stripe

kill switch: 3 lugs. When push button is out, circuit is open, when push button is depressed, have continuity betwee middle and one side lug . I believe this is what shorts out the CDI to kill the engine.

Light Switch: 4 lugs . Are there only two wires which go this switch with two lugs not used? The wires going to my headlights are brown and green with white stripe.



Wiring Harness coming to switches - 9 wires

Two wires with female plugs the size of the kill switch lugs. One is black with white stripe and one is green with white stripe. These wires go to the CDI. I believe they connect to the kill switch

7 remaining wires have no connectors on the end. They are just wires with insulation stripped off about 1/4" from the end. Colors of the 7 wires are: black, brown, red, Green, Green with white stripe, 2nd black wire, yellow with red stripe. Which of these wires go to the light switch (2?) and which go to the ignition switch (5?)? How should the harness wires be connected to the ignition switch wires? which color goes to which color? Where do the black wires go in the buggy?

If anyone has a wiring diagram specifically for the Carter Talon FX 150IIC, I would very much appreciate a copy as I have not been able to find one.

Can anyone help me with this Talon FX 150IIR? Thanks!