|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
 |
|
|
Thread Tools |
|
#1
08-26-2010, 09:13 PM
|
|||
|
|||
GY6 150cc "terminator" head gasket
I am in search of a headgasket for a "terminator" engine.
I ordered a set of GY6 gaskets and they don't match the original. The old head gasket measures about 57-58 mm for the bore and the diagonal holes measure between 79-80mm. The new gasket in the kit measures 59mm (bore) and 76mm (diagonal measurement) respectivly. Any ideas on what I have? Al "off road" 
|
|
#2
08-26-2010, 09:43 PM
|
||||
|
||||
|
sounds like a type b motor. do you have 4 valve cover caps or two?
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far
|
|
#3
08-27-2010, 10:53 AM
|
|||
|
|||
|
If you mean the through bolts that hold the valve cover to the head.. then two.
AL
|
|
|
|
