|
|
|
#1
11-10-2011, 07:32 AM
|
||||
|
||||
Break lines
I've tried to bleed the front left break line on my ASW Carbide and for some weird reason, I cannot get the fluid to flow. I was able to bleed the line on my other Carbide with ease, but this one doesn't want to do it. What could be wrong?
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! 
|
|
#2
11-10-2011, 07:59 AM
|
||||
|
||||
|
plugged bleeder, bad caliper, kink in brake line, bad master. Pull the bleeder screw completely out and see if you get flow. If not, pull the brake line off the caliper and see if you get flow out of it. That will let you "see" where the blockage is. If no flow out of the line before the caliper, then pull it at the master cyl. and check for flow out of that.
|
 |
|
|
