|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
 |
|
|
Thread Tools |
|
#1
08-19-2012, 08:51 AM
|
|||
|
|||
where to plug in the spark plug wire/coil?
Just bought this semi-basket case...fixed all steering, suspension, thanks. Now the wiring...downloaded the diagram from here but the spark plug wire/coil is dangling with 2 elect. spades on it. Have 2 other wires dangling...one is purple. Does not look like they should go there? Also coil has an attachment hole that looks like it should fasten somewhere on engine. Not wanting to experiment with this one and burn out coil and cdi? Any help is "really" appreciated.
|
|
#2
08-19-2012, 02:02 PM
|
||||
|
||||
Can you post a pic of what you have?
|
|
#3
08-19-2012, 04:07 PM
|
||||
|
||||
|
Is this issue with the Spiderbox you bought? Right under the passenger side of the carb is a mounting boss for the coil to bolt-on too- is this where the wires are? The purple coil wire from the CDI has only 1 spade connection, where as the FEV/choke purple wire goes into a 2 prong plug. Trace the dangling wires and find out where the come from.
|
|
#4
08-20-2012, 07:43 AM
|
|||
|
|||
|
thanx...the choke wires (2) I have plugged...the 2 wires from the CDI are black (I assume ground) the other is blue. Apparently they both plug into the coil as I can find nowhere else to put them. My Spiderbox has good spark, and gas into the carb but when I turn it over (jumping the relay as this is the only way I can do it at this point) it seems that the carb is not drawing but puffing outward? I believe I have a wiring problem (obviously) and perhaps something else going on. Thanx for the reply. Will get back w/ more info as it unfolds.
|
|
|
|
