GY6 150cc Talon No Spark

[tbutler01]

Hi guys. Got no spark. I have checked all the wiring and grounds. New coil and CDI. Have 120v ac to the cdi but only 0.2 v ac from the trigger lead. Trigger lead ohms out at 150 ohms. No output to coil from CDI. Good ground to cdi and kill switch is disconnected. Anyhow...my question is what should be the trigger voltage coming from the stator? I've seen everything on the forums from 0.02 all the way up to 20 v ac?? Pullin my hair out! LOL!
Thanks!

[tbutler01]

Have I got everyone stumped? Moderators? Thanks!

[bear]

I definatly dont know the answer to that question, but if i have a question that stumps me i always check with Tom @ sycpowersports, maybe you should give him a call!?

[tbutler01]

Originally Posted by bear

I definatly dont know the answer to that question, but if i have a question that stumps me i always check with Tom @ sycpowersports, maybe you should give him a call!?

Got it fixed or got spark now anyhow. It was a bad molex plug going into the CDI box. Pulled the pins, squeezed them back down, reinserted them and BAM! Got spark! Two were not making good contact. Hope this helps some of you!
Thanks!

[bear]

thats a lucky find!!! good deal