|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
 |
|
|
Thread Tools |
|
#1
07-19-2010, 03:44 PM
|
||||
|
||||
Oil dripping
There's oil coming out of the tube in the attached picture. Is this normal? I'm assuming not.
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! 
|
|
#2
07-19-2010, 07:44 PM
|
||||
|
||||
|
thats your breather vent for the transmission gears. Normaly you won't get any oil out of that tube unless the motor has been flipped over. Because your motor has just had some work done, they probablly rolled the motor over a few times while working on it. most likely this will clear up after a few hours of run time. To be on the safe side , check your trans oil level to insure that it has not been over filled or the mechanics flipped the motor and lost some oil.
|
|
#3
07-19-2010, 08:59 PM
|
||||
|
||||
|
ckau
is right they probaly flipped your motor while working on it check the oil level to be sure its okay my breather hose for the top of motor and my breather vent are both hooked to my chain guard on top that way if either puts oil or trans out it goes onto my chain but i check my levels often
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far
|
|
#4
07-20-2010, 10:46 AM
|
||||
|
||||
|
Ok. Thanks guys.
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE!
|
|
|
|
